E61 Group Gasket: 8.5 mm

Does not fit into my ECM Mechanika, misinformation!

I have not installed it yet - no need - the existing one does have an indentation (from removing the filter from the head), but it is still holding. As usual, the Lelit is fantastic - getting a machine without flow control is not recommended...................

very good

I purchased this to ise on the Profitec P500. The gasket (which was what needed replacing) was pretty snug and I could not seat it properly. I reached out to Clive and in short order I was sent another, identical gasket that also was difficult to seat. I used the handle of a spoon to press it in place and it works as expected. The original Profitec gasket had a slightly reseeded edge that faced the machine, the replacement did not. I suspect this is the reason it is a tight fit. Next time I will source the replacement from Profitec for a better fit.

Still issues with repair,

The new gasket is not the same as shown in the photo but red color silicon gasket. It works well with softer feeling.

Perfect fit.

It fit and solved my problem...awesome to have easy part availability...my Profitec 700 back in action

Perfect durometer for my group head and portafilter. Many replacement gaskets are too stiff. This particular one is perfect.

This was a perfect fit for my Rocket Giotto Evoluzione 2.

The Clive support group helped me to identify and order the repair part/gasket needed for my esspresso machine. The were slso very helpful in pointing out YouTube instructional tepair videos. Great support and a job well done.

Thanx. I think of you folks every morning brewing the first esspresso shot!

You guys have the best coffee, coffee beans, and best customer service in town! Thank you so much especially to Kody for all you do for us!